Amazon· Outillage & atelier

FYSETC 3D Printer Parts UCAN Board V1.0 Based on STM32F072 USB to CAN Adapter Type C Interface Support CANable/Candlelight/Klipperr Firmware-Pack of 1

Name: FYSETC 3D Printer Parts UCAN Board V1.0 Based on STM32F072 USB to CAN Adapter Type C Interface Support CANable/Candlelight/Klipperr Firmware-Pack of 1
Price: 13.13 USD
Availability: InStock

13.13 $≈ 11.40 €

Le prix en résumé

Vendu par Amazon à 11.40 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 31.68 €. Prix relevés le 2026-08-18.

Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.

Annonce de place de marché : l'article est vendu par un particulier ou une boutique tierce, pas par la plateforme. L'état, le stock et les délais sont ceux du vendeur, et l'annonce disparaît une fois l'article vendu.

En stock★ 4.8 (0 avis)

Voir chez le vendeur ↗

Coût total livré estimé

Détail du coût total livré
Article	11.40 €
Frais de port	15.00 €
TVA (20 %)	5.28 €
Total livré	31.68 €

Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.

Description

1. What's UCAN? It is an open source USB-to-CAN interface board, based on STM32F072 and candleLight open source firmware, and supports linu/win/mac multi-platform. Of course, you can also develop your own firmware to use, it is completely open source. 2. Firmware preloaded: UCAN has already burned the firmware when it leaves the factory. Generally, there is no need to burn it again. If the CAN device appears on the computer plugged into windows PC , it means that it is working normally. If need to reflash the firmware, please refer to the steps on WIKI.FYSETC Module-Can. 3. Hardware: UCAN is designed based on STM32F072CBT6, PA11/PA12 is connected to USB-C, and PA8/PA9 is connected to CAN interface. 3-pin screw plug terminal: CANH, CANL, GND. 4. About Terminating Resistors: We provide two ways to terminate the resistor, the default is composed of two 59R resistors (R1/R2). The alternate location consists of a 120R resistor and a two-pin jumper.There is no difference in general use, the default is onboard. More info please check the Schematic Diagram on FYSETC Wiki. 5. Features: Supports CAN2.0A and B, baud rates up to 1M. Headers to enable/disable termination, On-board termination resistors (2 x 59R) are used by default.